The Yandina combiner 100 is a voltage-sensing relay (13.3 volts) which connects two batteries together when either is receiving a charge. When the charging ceases, the relay opens so that each battery operates independently. Supplemental battery banks can be added by using an additional combiner for each bank. You never have to worry about switching to "both" when your engine is running and forgetting to switch back to save your starting battery from discharge when you stop.

Features

• 75 amps continuous rating, 400 amps closing current (2 seconds)
• Suitable for alternators up to 100 amps, up to 18 volts. Larger charging sources should use the Combiner 150
• Waterproof - Ideal for exposed mounting in open boats
• No voltage drop so batteries reach full charge
• Electronic thermal monitoring with shutdown
• Minimal wasted power, no heat sink or cooling required
• Can be used on alternators with internal or external regulators
• Alternators with external voltage sense require no special wiring
• Simple basic installation, two battery wires and ground
• Complete with all cables and terminals for basic hookup
• Green LED indicates when combined
• Red LED indicates thermal overload shutdown
• Draws no current when batteries are not being charged
• Draws less than 150 milliamps when charging is in progress
• Optional external remote control for off, automatic, on
• Remote ON can be used for assisted engine starting
• Remote OFF can be used to disable the combiner
• Optional regulator feature to limit voltage to safe level for sealed AGM type batteries
• Withstands ambient temperature to over 175 F for exposed or engine compartment mounting
• No diodes to burn out if accidentally shorted
• Compact - only 1.75 wide (plus mounting) by 1.125 thick by 1.5 high (plus cables)